The Seconds Shelf
Perfectly usable. Not quite perfect.
Every piece here exists exactly once. Some are cancelled orders or returns with nothing wrong with them. Some are test prints we liked but do not need. A few have a flaw we would not ship to a regular order, and that flaw is written on the card and photographed first. Pick one up for less than the made-to-order price, and it ships in a day or two because it is already made.
- Final sale. The flaw you see is the flaw you buy. No change-of-mind returns on shelf pieces.
- Shipping damage is still on us. Replaced or refunded like any order.
- One of each. When it is gone it is gone; a sold piece stays here marked Sold for a while so nobody wonders.
- Ships in 2 business days (the two Silos take a day longer: their stand and tray print after you order).
- Like new
- Cancelled orders, returns and clean test prints. Nothing wrong with them; we just do not need to keep them.
- Seconds
- One honest flaw, named on the card: a layer line, a darker band, a rough edge. Fully usable.
- Rough but usable
- A few flaws rather than one. Still a working planter, priced like it.
Nothing wrong with it. A cancelled order that had already been printed, so it goes at the shelf price.
Some of the inner support walls are missing and one band of layers printed thicker than the rest. It holds a plant exactly as it should; the difference is inside the pot and in that one band.
A visible layer line and a skipped section of wall low on the pot. The stand and the drip tray print fresh after you order, so allow an extra processing day.
The top third printed a shade darker than the rest of the pot. The stand and the drip tray print fresh after you order, so allow an extra processing day.
Printed without drainage holes and sold without its tray, so use it as a cachepot with a nursery pot inside. Otherwise brand new.
Printed without supports, so the undersides of the leaves are rougher than our usual finish. Solid and watertight.
Fine strings of filament where the supports came away, most of them underneath. A minute with a nail file clears the rest.
A layer shift partway up, so one band of the body sits a hair off the one below it. Stands straight and holds a full set of knives.
A clean print with no flaws. Sold on its own because its matching knife caddy had a layer shift; that one is on the shelf too.
Rough edges along the bottom of the pot and the base, and a small gap where two sections meet. Sits flat and holds a plant fine.
Nothing wrong with the pot itself. It comes without its drip tray, so plant it in a liner or set it on a saucer.
A test print in a purple and blue filament. No flaws. This is the plain Sway, without a water insert.
Small holes in the relief on the outside where the pattern did not fully close, and the liner is rough. Plant in the liner and it works as intended.
One layer line partway up, from a power blip mid print. Everything else about it is a 10 out of 10.